top of page
Pocket Gopher Kiln

The kiln shown here was completed in 2026 by Alan Perillo and Jack Orgill as part of Jack's apprenticeship with Alan.​

​

The bricks used to build the kiln are made from naturally occurring high-temperature clay from our property.

​

This kiln serves as an experiment in brick-making and firing techniques.

​

The name "Pocket Gopher" is both an homage to a local burrowing critter, the Mazama pocket gopher, and to Southern groundhog kilns, which are built underground. "Pocket Gopher" felt fitting because this kiln is smaller than and not quite the same shape as the traditional groundhog kilns of the American South.

The Pocket Gopher Kiln built by Alan Perillo and Jack Orgill
Building the Pocket Gopher Kiln

The kiln building process began by extending the existing kiln shed to make room for this new project.

framing the kiln shed extension
applying roofing to the kiln shed extension

Then clay was dug and processed in preparation for making bricks.

digging clay
dried clay

The clay was thrown and pressed into molds by hand to form the bricks. A total of 650 brick were made.

mixing brick material
brick material and a series of handmade bricks

The dried bricks were loaded into our large kiln and fired to a low temperature, making them more durable and resistant to erosion.

loading handmade bricks into kiln
bisque-fired handmade brick
firing handmade bricks

The foundation of the kiln was dug by hand, with shovels and pickaxes. A tractor and wheel barrows were used to move the dirt dug up out of the way.

Alan Perillo and Jack Orgill in the hand-dug Pocket Gopher Kiln foundation

Bricks were laid on the ground in load-baring areas to form the outline of the kiln. The walls were stacked straight up with mortar to aid leveling.

Perillo and Orgill laying kiln foundation bricks
Perillo standing near straight walls of unfinished kiln

A small wooden form was made and placed within the straight walls to support the arch as it was laid.

small wooden arch form
Perillo and Orgill laying the kiln arch

Dirt was backfilled around the kiln to brace the straight-walled foundation. Large rocks helped brace and cap the opening and edges of the kiln.

 

The finished arch was covered in insulating fiber and a final sealing coat.

insulating fiber on kiln
skin coat / mudding on kiln

The chimney was stacked with a slight taper and room for a damper until it extended through the roof of the kiln shed. Corner braces were applied to keep the bricks in place.

building kiln chimney
kiln chimney with damper slot
Perillo Pottery kiln shed with new Pocket Gopher chimney

Finally the arch form was removed, leaving a self-supporting brick arch and a finished kiln!

Alan Perillo and Jack Orgill finishing the Pocket Gopher Kiln
Jack Orgill in the Pocket Gopher Kiln
Alan Perillo and Jack Orgill in front of the finished Pocket Gopher Kiln

Join our Newsletter

​

Occasional updates about what we're making and where you can find it.

©2019 by Perillo Pottery.

bottom of page